EN
17
IMPORTANT: PLEASE READ THIS MANUAL THOROUGHLY BEFORE ASSEMBLING AND RIDING ON THIS BIKE.
WARNING:
. For Ages 2 and Up
. Maximum Child’s weight: 30KGS
. Check and tighten bolts and screws before every ride.
. Make sure all components are functioning properly before every ride.
Inflate the tyres to no more than the maximum degree marked on the side of the tyre.
. If any component is damaged or not functioning properly, it should be replaced before the item is used.
IMPORTANT
WARNING:
An Adult must assist in the initial assembly of the bike.
Be sure your bike is fully assembled before riding.
Read and understand this user’s manual before using the bike.
PRECAUTIONS FOR SAFETY
This Bike is not recommended to kids under 2 years of age or over 30kgs.
Please read and follow the safety precautions listed below, failure to do so could result in injury or damage to your bike.
Please instruct your child on proper operation of this bike, also instruct your child to follow the safety precautions listed below.
WARNING: DO NOT TAKE THIS BIKE TO ROADS.
A. Wear a helmet.
B. Do not ride near motor vehicles.
C. Practice braking in a safe environment.
D. Never ride near steps, sloped driveways, hills, roadways, alleys, swimming pool areas or other sides of water.
E. Never ride the bike in wet weather. Wet surfaces may increase stopping distance when braking.
F. Do not ride at night.
G. Don’t ride too close to pedestrians.
H. Avoid hazards which may hinder your ability to control your Bike. Potholes, ruts, uneven pavement, storm grating, gravel, curbs,
leaves, puddles and debris can all have an effect on your riding and result in loss of control.
I. Do not ride off road or on rough pavement.
J. Keep both hands on the handlebar.
CAUTION: BRAKE GENTLY TO AVOID SUDDEN STOPS.
ASSEMBLY INSTRUCTIONS
Remove the bike from box and check for any missing or damaged parts.
(Note the tyres come inflated with air but may lose some air during shipping.)
ASSEMBLE THE HANDLEBAR AND SEAT
ASSEMBLE THE HANDLEBAR
1. Put the bottom handlebar bearing on the fork(Fig.1 b).
2. Insert the handlebars into front fork tube(Fig.1 c),
3. put the upper bearing(Fig.1 d).
To Next Page
Loading...
