Name: Master RIDE
Brand: Master
Rating: 4 (1 reviews)

To Next Page

To Previous Page

INSTRUCTIONS OF ASSEMBLY

Part One

Please put the wheel in the fork, then assemble the washer and nut to fix them.

For front wheel, the same way as showed on the picture.

Important: Check the tightening of the nut ( with the help of wrench )

Part Two

Place the bracket in the column steering, using the wrench to tighten the

long screw.

Important: Tighten the stem well and ensure that the bracket is in the

correct center.

Part Three

Please use the wrench to fix the four screws and nuts, place the handlebar

by tightening the nuts in cross.

Attention: Please check the spigot and counter-nut are correctly tight.

Part Four

After finished the assemblage, you must adjust the back brake and

inflatable tyre with a suitable pressure.

IMPORTANT: PLEASE READ THIS MANUAL THOROUGHLY BEFORE

ASSEMBLING, RIDING OR PERFORMING MAINTENANCE ON THIS

SCOOTER.

WARNING:

 Maximum Child’s weight: 80 KGS

 For ages of 6 and Up

 Check and tighten bolts and screws before every ride.

 Make sure all components are functioning properly before

every ride.

 Rider should wear proper protection while using this product.

Please wear a helmet, knee and elbow pads, and shoes. This

will greatly reduce the chance of injury, but cannot protect form

all injuries.

 Maintain inflation of the tyres to no more than the maximum inflation marked on the side of the tyre.

 If any component is damaged or not functioning properly, it should be replaced before the product is used.

 Avoid sharp bumps, drainages, grates and sudden surface changes.

Questions and Answers:

Need help?

Do you have a question about the Master RIDE and is the answer not in the manual?

Master RIDE Specifications

General