Mastercare MB-80 - Advanced Options and Chair Components; Toileting Option Procedures

Integrity Bath MB-80 Operating Instructions
______________________________________________________________________________________________
MB-80 Operations 2/18/13 800.798.5867
11
Integrity Bath Toileting Option Operational Instructions
Mast erC are
Removable Toileting Option Accessory Items Identification:
Exploded View
To Remove Toilet Lid Lift Off
With Handle and Hang On The
Hanger Peg By Inserting It
Through The Round Hole On
The Key Hole and Indexing It
In the Slot.
Tub With Toilet Lid Tub With Toilet Lid
Seal In Place Seal Removed
Basic Toileting Option Operating Procedures:
Follow all general procedures in the manual and wall charts for the type of Integrity Bathing System you are using up
through the docking procedure. Then follow the basic procedures for the Toileting Option listed below as part of the
final transfer, positioning, and toileting procedures before the bath:
1) After docking the transfer system just before you transfer the chair with the resident into tub make sure the toilet
lid is removed and inserted on the hanger pin as shown
in the exploded view above.
2) Unlatch the chair from the Carrier and transfer the resident into the tub latching it into the next to last position
inside the tub. Remove the Bed Pan from under the chair. Then unlatch and re-position the chair all the way back
latching it into place.
3) Following the general instructions, begin filling the tub with proper temperature adjusted water until the water is
just above the foot-well then shut off. CAUTION: Do not fill above the rim of the built-in toilet. Wait a short period of
time about 30 to 60 seconds (this may vary between residents) to see if the warm water effect (if it hasn’t already
happened) induces a bowel movement. The warm water effect, to induce a bowel movement, can be enhanced by
also showering the resident during this period of time.
4) If a bowel movement occurs during the above procedure, clean up any residual matter with the shower wand, then
flush the toilet with the Toilet Flush Handle on the right side of the tub just below the Drain Handle.
5) Unlatch the chair and latch into the next position up. Un-hook the toilet lid from the hanger peg, position over the
open toilet and press firmly into place until sealed. Reposition the chair all the way back and latch into place, Then
continue filling the tub to the desired level. Resume the bathing routine according to the general Operating Procedures
in the manual.
6) After the bath is completed and the tub is being cleaned and sanitized for the next bath, remove the toilet lid, clean
and sanitize it and hang it back on the hanger peg for the next bath. Remove the screen, after flushing any residual
fecal matter off it with the disinfectant wand, clean and sanitize with the tub brush, let dry and reinsert inside the toilet
opening.
Form # 00095 07/18/11