Integrity Bath MB-80 Operating Instructions
______________________________________________________________________________________________
MB-80 Operations 2/18/13 800.798.5867
Disinfectant Dispensing System Operating Instructions
Disinfectant
Wand
Disinfectant On/Off Flow
Control Valve Located
Inside Under Removable
Service Panel
½” Male Pipe Fitting
On Reservoir Models
Only For Disinfectant
Wand
Dema Metering
Adjustment Screw
Located Here Under
Black Hole Plug
Cap With
Dispensing
Hose
Strainer
Foot
Bottom of
One Gallon
Jug
To Dema
Valve
Metering Adjustment
Screw
Dema Valve
How to Connect the Dispensing System to the MasterCare Cleaner/Disinfectant Jug:
1) Remove the cap and seal under the cap on the one liter jug of cleaner disinfectant.
2) Insert the foot strainer attached to the cap with dispensing hose into the one liter jug so that the strainer foot is on
the bottom of the jug. If replacing an empty one liter container check the strainer at the bottom of the foot strainer.
Remove any accumulated debris that can clog it up.
3) If first time connection on new install follow “How To Operate” instructions below to prime the system. As soon as
solution starts to flow from the disinfect wand turn off the flow control knob.
How to Operate the Dispensing System:
1) Grasp the red handled disinfectant wand and pull up out of the holder. Point the nozzle inside the tub. To activate:
turn the disinfectant control valve counter clockwise until fully on.
2) Follow the Operational Instructions provided with the tub to clean and disinfect it.
3) To deactivate: turn off the disinfectant control valve by rotating it clockwise until fully shut off.
/!\ Warning: Heed all label warnings on the cleaner disinfectant you are using in this dispensing system.
Form # 00074 D
To Next Page
Loading...
