Integrity Bath MB-80 Operating Instructions
______________________________________________________________________________________________
MB-80 Operations 2/18/13 800.798.5867
`
Integrity Transfer Chair Pad and Belting Instructions
Pillow
Strap
Knob
Pillow Strap
Part # 802970
Top
View
Front
View
Top
View
Side
View
Side
View
Seat Back Pad
Part # 800360
Spa
Pillow
Part #
804590
Seat Bottom Pad
Part # 800370
Side
View
1) For Seat, Back & Leg Rest Pads
attach with pad straps as shown. Make sure snaps
are on the back side of the pad and fully snapped
together as shown. The straps are pre-adjusted.
To facilitate connecting the snaps on all pads, snap
together on the top side, then rotate the strap until
snap is on the back side of the pad.
To disengage straps grab end of the strap and pull
apart. Pull strap out through one of the attachment
holes.
2) For the Headrest Pad attach by looping the holes
in the pillow strap over the pillow strap knob. Adjust
so pad is secure. To disengage pull strap off of strap
knob.
Sanitize all belts and pads between baths as
instructed in operational procedures.
CAUTION: Do not use Clorox type bleaches to clean
and/or disinfect the pads and straps. Also some
shampoos, bath oils/additives and Betadines have
substances in them that can stain some surfaces.
Use of such products can damage and/or stain the
pads and straps over time.
Maintenance Tip: Treat pads & straps weekly
with "Armor All" vinyl protecterant according to the
label directions. This will prolong their life, make
them easier to maintain, help prevent them from
staining or sticking to the surface of the chair.
Long Pad Strap
With Snaps
Part # 800840
F its All Pads
CAUTION: REMOVE THE PADS DAILY;
otherwise damage to the powder coating may
occur. Damage may void the warranty.
To Next Page
Loading...
