Integrity Bath MB-80 Operating Instructions
______________________________________________________________________________________________
MB-80 Operations 2/18/13 800.798.5867
Open The Door And Engage The Carrier:
Open the door by rotating cam arm down and
pulling straight out on the Black Door Latch
Release knob. The door will automatically rise up
to the level needed to rotate it out of the tub.
Rotate the door as far as you can so it is not in the
way of the carrier. Roll the carrier up to the tub
until the carrier rails align with the tub rails. Push
until it is engaged in the Latch Pin Receiver. Lock
both Locking Casters by stepping down on the
Brake Lock Tabs.
Move The Individual Out Of The Integrity
Bath:
Warning: If using the chair with recline seat back
it must be returned to the full upright position
before transferring individual out of the Integrity
Bath. Failure to do so could result in injury to the
individual. Pull up on the Main Chair Release
Lever and roll the individual forward until the chair
is fully on to the carrier and automatically latched
into place. Before disengaging the carrier from the
tub, make sure the chair is securely latched into
place by pushing the chair back towards the tub.
If properly latched into place, the chair will not
allow itself to be pushed off of the carrier rails onto
the tub rails. The gravity latch is engaged. Finish
drying the individual. Insert commode back
underneath the chair seat.
Disengage The Carrier From The Tub:
Unlock both Locking Casters by releasing the
brake lock tabs. Step down on the Carrier Latch
Pin Release Lever to release the latch pin and
push the chair away from the tub. Turn off the
BathAire
(SM)
by pushing the BathAire
(SM)
On/Off
Touch Pad. You are now ready to transfer the
individual back to their room or other areas as
appropriate.
Main Chair Release
Carrier Latch Pin Release
Lever
To Next Page
Loading...
