Integrity Bath MB-80 Operating Instructions
______________________________________________________________________________________________
MB-80 Operations 2/18/13 800.798.5867
Fill The Tub Continued:
WARNING: The temperature of the bath water
must never exceed 110°. If you are unable to
adjust to the normal level of 96° to 105°, remove
the individual and report the problem to
maintenance. Do not use bath until the mixing
valve is serviced to correct the problem. Failure to
heed this warning could result in a scalding injury
to the individual.
Shampoo & Body Wash:
During the normal bath cycle you can shampoo
the individual’s hair and wash their body with
MasterCare’s specially formulated Shampoo and
Body Wash. Simply push the touch pad as you
are filling the bath to add the Bath Oil directly into
the bath water. Hold your hand under the
dispensing portal to receive the shampoo/body
wash in your hand. Bath or assist the individual
with their hygiene needs. To rinse, lift the shower
wand from its holder, located on the tub deck, and
then direct the nozzle towards the open water in
the tub. Turn the shower wand on by turning the
Shower Wand Control Valve counter clockwise to
full open. Adjust the shower water temperature to
the desired individual comfort level using the
Mixing Valve control valve. Test the water
temperature on your wrist before showering the
individual. Turn off Shower Wand Control Valve
when complete by turning knob clockwise. Return
Shower Wand to its holder. Caution: Do not only
turn off the black switch on shower wand; the
valve must be turned off to avoid back
pressure build up. If your wand does not have this
switch please disregard this caution.
End of Bath Cycle:
At the end of the bath cycle, while leaving the
BathAire
(SM)
on, open the drain by pulling up on the
Drain Open/Close Lever. Dry as much of the
individual as you can before removing them from
the tub.
Liquids Dispensing
See page 13
To Next Page
Loading...
