headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
15
TO ATTACH THE BATTERY (
fig. 5
)
1. Make sure that the sander is switched off.
2. Align the raised rib on the battery pack with the
grooves on the pole saw, and then slide the battery
pack onto the pole saw.
TO DETACH THE BATTERY (
fig. 5
)
1. Make sure that the pole saw is switched off.
2. Depress the battery-release button located on the
front of the battery pack to release the battery pack.
3. Pull the battery pack out and remove it from the pole saw.
START/STOP THE TOOL (
fig. 6
)
1. To turn the saw on, grasp the foam and rear handles
firmly, using both hands.
2. Press the lock-off button, and then squeeze the
trigger switch.
3. To turn the saw off, release the trigger switch and
allow the chain to come to a complete stop.
OPERATING INSTRUCTIONS
WARNING!
• Make sure that no objects or obstructions are in the immediate vicinity and could come in contact with
the bar and chain.
fig. 5
Battery-release button
fig. 6
Lock-off button
Trigger switch
To Next Page
Loading...
Need help?
General