EasyManua.ls Logo

MasterCraft 054-1332-6

MasterCraft 054-1332-6
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
headline bars
continuation tabs
notes
warnings
9
Before performing any kind of work on the machine (e.g., maintenance, tool change,
etc.) as well as when transporting and storing it, always set the direction-of-rotation
switch to the centre (locked) position. Unintentional activation of the On/Off switch may result
in personal injury.
Do not open the battery. There is risk of a short circuit.
Protect the battery from heat and fire. There is risk of explosion.
Wear ear protectors when using the drill/driver. Exposure to noise can cause hearing loss.
Use protective gloves when removing the bit from the tool, or first allow the bit to cool
down. The bit may be hot after prolonged use.
Use protective gloves when operating the tool. Protective gloves can help to keep youfrom
being burnt and hurt.
Keep your hands away from the motor-housing vents. Hot gas comes from the vents
during operation.
Release the trigger immediately when a screw is tightened to avoid breaking the screw.
For best results, your battery and tool should be charged, used and stored in a location
where the temperature is more than 5°C (41°F) but less than 40°C (104°F). Do not store
outside or in vehicles.
The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V ..................... Volts
A ..................... Amperes
Hz ................... Hertz
W .................... Watts
min ................. Minutes
................. Alternating current
or d.c .............. Direct current
n
0
................... No-load speed
............... Class II Construction
…/min ........... Revolutions or reciprocation per minute
............... Grounding terminal
RPM ............... Revolutions per minute
.............. WARNING – To reduce the risk of injury, user must read instruction manual.
.............. WARNING – To reduce the risk of injury always wear eye protection.
.............. WARNING – To reduce the risk of injury always wear ear protection.
SAFETY GUIDELINES

Related product manuals