WARNING!
DANGER!
Read, understand and observe all instructions in this manual before using or operating the tool for which
it is written and supplied. Ensure that anyone who is to use the tool has read and understood the instructions
provided.
Failure to observe any of the following instructions could result in severe personal injury to tool user and
bystanders or cause damage to tool and property!
• Always wear safety glasses complying with OSHA/ANSI requirements Z87.1.
• Wear a mask or respirator when dust is generated.
• Keep bystanders out of the work area while operating the tool.
• WARNING! Always ensure that the work area is clear of any flammable materials, liquids or gasses,
because the use of this tool may create sparks.
• Wheel guards and eye shields must be properly adjusted and tightened.
• During each start-up, stand to one side of the grinder and switch it on. Let the grinder operate at
full speed for approximately one minute so that any undetected flaws or cracks will become
apparent.
• Use only 6” (15.24 cm) wheels suitable for 3450 RPM or over.
• Keep guards in place and working properly.
• Keep hands clear of grinding wheels.
• Always make sure wheels are properly mounted.
• Secure the tool when working to prevent unexpected movement.
• Never reach behind or beneath the grinding wheels.
• Unplug from power supply before adjusting or servicing. The grinding wheels continue to rotate
after the tool is switched off. Always allow wheels to stop before adjusting or servicing.
• To avoid electric shock, DO NOT use in damp conditions or expose to rain.
• When fitting a new grinding wheel, always check that the stated maximum RPM meets or
exceeds that stated on the grinder. Also check the new wheel for damage, such as flaws or
cracks. If the wheel appears satisfactory, fit it to the grinder.
• When a new grinding wheel has been fitted, stand to one side of the grinder and switch it on.
Let the grinder operate at full speed for approximately one minute so that any undetected flaws
or cracks will become apparent.
• Use only accessories that are recommended by the manufacturer for your model.
• DO NOT attempt to cut anything with the grinding wheel.
• Grounded tools must be plugged into an outlet that has been properly installed and grounded
in accordance with all local codes and ordinances. Never remove the grounding prong from
the plug or modify it in any way. Do not use adaptor plugs. If in doubt as to whether the outlet is
properly grounded, consult a qualified electrician.
• Do not use the tool when tired or under the influence of drugs, alcohol or medication.
• Do not wear gloves, neckties, jewellery or loose clothing when using tool. Keep hair tied back.
• Ensure the power switch is off prior to plugging in the tool.
• WARNING! Replace cracked grinding wheels immediately.
• Do not overtighten spindle nuts.
• Spacing between tool rests and wheels should be set to 1/8” (3.2 mm) or less; hold workpiece firmly
against tool rest.
• Service on these tools should only be performed by an authorized, qualified technician.
• Failure to comply with these warnings may result in serious personal injury.
• There is a risk of injury due to accidental starting; do not use this tool in an-area where children
may be present.
!
SPECIFICATIONS
5
model no. 055-3521-2 | contact us 1-800-689-9928
Motor: 120V, 60 Hz, 2.1A, 1/3 HP
Wheel Size: 6 x 3/4" (15.2 x 1.9 cm) with 1/2" (12.7 mm) arbor
Speed: 3450 RPM (no load)
Wheels: 36- and 60-grit
Weight: 15 lb 2 oz (6.9 kg)
4
SPECIFICATIONS
SAFETY GUIDELINES
To Next Page
Loading...
Need help?
General
