OPERATING INSTRUCTIONS
19
AIR-POWERED STAPLER 058-8132-2
Clearing a jammed staple
To clear a jammed staple
• Disconnect the tool from the air supply line.
• Remove the staples that are stored in the tool’s magazine.
• Operate the latch and pull it back to open the magazine.
• Use pliers or any appropriate tool to remove the jammed staples.
• Reload the staples into the tool magazine.
• Slide the pusher against the staples to close the magazine and verify that the latch is moved
to its original position.
• Reconnect the air line to the tool’s air inlet.
• Test fire 3 to 5 staples into a piece of scrap wood in order to ensure proper operation.
Note: If the staples continue to jam, please call 1-800-689-9928.
CAUTION!
Potential hazard that may result in moderate injury or damage to
equipment.
• Operate the tool with the utmost care when it is connected with the
air compressor. Failure to comply may result in moderate injury or damage to
equipment.
To Next Page
Loading...
Need help?
General
