26
Check valve stuck open.
Pressure bleeder valve on pressure
switch has not unloaded head
pressure.
Compressor attached to extension
cord.
Loose electrical connections.
Paint spray on internal motor parts.
Possible defect motor.
- Bleed line by moving pressure switch
lever to OFF position before restarting.
If bleeder valve does not open, replace
bleeder valve.
- Link additional air hoses together to
acquire more length;
DO NOT USE AN EXTENSION CORD
- Contact authorized service centre.
- Have checked at service centre. Do
not operate compressor in a paint
spray area.
- Have checked at a service centre.
To Next Page
Loading...
Need help?
General
