MasterCraft 2007 ProStar User Manual

2007 MasterCraft Owners Manual - Page 17-5
Step 7: Install the raw water impeller and reconnect the hoses to the raw water pump. Use a new gasket, even if the
one removed at winterization time appeared in good condition.
Step 8: Install new spark plugs.
Step 9: If applicable, reconnect the hoses to your heater or shower.
Step 10: Check the engine compartment and bilge for signs of nesting animals. Clean as necessary.
Step 11: Checktheconditionofthedistributorcapandrotor(whereapplicable).Replaceifeithershowssignsof
wear, damage or corrosion.
Step 12: Checktheentireenginesystemforuid,oilandcoolantlevels.Addasnecessary.
Step 13: Check the entire engine for cracks or leaks caused by freeze damage.
Step 14: Check all hose clamps for tightness. Install the bilge drain plug and the rear drain plug in boats equipped
with certain types of ballast systems.
Step 15: Grease the propeller shaft taper and install the propeller.
Step 16: Perform the daily maintenance. If not performed prior to storage, perform the annual maintenance.
Step 17: Iftheboatisequippedwiththeoptionalfresh-watercoolingsystemandwasdrainedforstorage,llthe
system with fresh coolant solution per instructions.
Step 18: Checkthealignmentbetweentheoutputangeonthetransmissionandthepropellershaftange.Ifthe
maximumfeelergaugethatcanclipbetweentheangefacesatanypointis0.003”,theunitisproperly
aligned. If a thick gauge can be inserted at any point, the engine must be re-adjusted until proper alignment
is obtained. This should be performed by your dealer.
Step 19: Forallmodels,withtheboatinthewater,cyclethekeyONandthenOFFtwoorthreetimes,allowing10
seconds between key cycles, before cranking the engine. This allows the fuel pump to prime the fuel lines;
then start the engine. In the event the engine does not respond, allow a two-minute cool-down period for
every30secondsofcranking.Whentheengineres,keepaclosewatchoverthegaugereadingsand
checkforleakageandabnormalnoises.Keepspeedslowfortherst15minutestoallowtheenginetoreach
normal operating temperatures.
Step 20: In ProStar 197s equipped with ballast bags, when
reconnecting the hook-ups, be sure that you squeeze
the prongs to help slide back on. Dish soap or some
similar product will help slide the connects back to-
gether. Note that the red ring goes over the raised
ring to ensure a working connection.

MasterCraft 2007 ProStar Specifications

General

Brand	MasterCraft
Model	2007 ProStar
Category	Boat
Language	English