2007 MasterCraft Owners Manual - Page 5-6
Turning On RPM Cruise Control Mode: To turn on the Cruise Control System in RPM Control mode, make
sure that the RPM/SPEED mode selection switch is in the RPM position and that the current engine speed is at least
400 RPM less than the Set Point. Press and hold the ON/OFF switch in the ON position for approximately one sec-
ond. The LCD should now display the current engine speed, the RPM icon should be illuminated and the LOCK icon
should be blinking.
Turning On Speed Cruise Control Mode: To turn on the Cruise Control in Speed Control mode, make sure
that the RPM/SPEED mode selection switch is in the MANUAL (center) position and that current engine speed is at
least 1200 RPM. Then press and hold the ON/OFF switch in the ON position for approximately one second. The LCD
should display the current engine speed and the LOCK icon should be blinking.
Manual Set Point Adjustment: The Manual Set Point can be adjusted using the +/- switch. The LOCK icon
will disappear and the LCD will display the current Set Point. Short presses of the +/- switch will increase or decrease
the Set Point by 20 RPM. Holding the switch increases or decreases the Set Point by 100 RPM. The Manual Set Point is
limited to a minimum of 1200 RPM and a maximum of 5000 RPM.
Using Speed Control Mode: Manual Control works basically in the same way that RPM Control Mode does.
The difference is that when the system is turned ON in manual mode the Set Point is set to the current engine speed.
For example, if the Cruise Control is OFF and the engine speed is 2500 RPM, and the system is turned on, the engine
will hold the engine speed at 2500 RPM.
Disengaging the Cruise Control System: There are two ways to disengage the system. Pulling back the throttle will dis-
engage the system at any time. The system remains ON and can be engaged by accelerating the boat until the LOCK
icon stays illuminated, or by moving the ON/OFF switch to OFF. It is recommended that the throttle be pulled back
before turning off the system.
To Next Page
Loading...
Need help?
General
