When trailering a boat or when operating the boat on the water,
fold the sunshades down to reduce wind resistance. High speeds
put large amounts of air pressure on the sunshades and hard top
and can cause them to collapse causing serious injury and damage
to the boat.
Mooring Cover with
Anti-Pooling System
Models
All Aviara models are available with optional anti-pooling
mooring covers.
Purpose
Anti-pooling covers are designed to prevent water and debris
intrusion while the boat is docked or stored. Mooring covers
mount around the boat and cover everything above the
stainless steel rubrail. Mooring covers feature an integrated
anti-pooling system that lifts the cover up so that snow or
water drains off the side rather than pooling on top of the
cover. Anti-pooling covers use a drawstring system to lift the
canvas mooring cover upwards.
Location
Mooring covers mount over the boat and wrap just below the
stainless steel rub rail to secure the canvas snugly around the
boat. Use the ratchet straps to secure the canvas. Use hooks on
the underside of the hard top to create an anti-pooling system
that drains debris off the sides of the boat.
Operation
To install a boat cover with the anti-pooling drawstring:
1. Cover the bow and the forward portion of the cockpit with
the canvas designed to fit the bow.
2. Continue covering the boat from bow to stern until you reach
the windshield. Ensure that the windshield door is closed.
Continue covering the boat.
3. When you reach the midship, mount the anti-pooling loop to
the hooks on the underside of the hard top.
To Next Page
Loading...
