2017 OWNERS MANUAL / 322
operations, there will be some vibration, and this may loosen hard-
ware over time.
• Check that all required Scheduled Maintenance Checks and Ser-
vices (see following sections) were performed.
Afer Operation
• Check for fluid leaks.
• In boats equipped with a ballast system, drain water from the
ballast system before placing the boat on the trailer. If the boat
has ballast-pumping assistance to remove water from the ballast
system, note that the engine must be running at least 1500 RPM
during the pumping process (for both fill and empty operations).
This will necessitate draining water prior to ceasing operation of the
boat and loading on the trailer. More information regarding ballast
systems appears in various sections of this Owner’s Manual, but
pay particular attention to the information under Boat Operations.
• Check the fins (where equipped), propeller, rudder and shaft for
damage after removing the boat from the water.
To Next Page
Loading...
