2023 OWNER’S MANUAL
/
142
approximate planing speed—also known as crossover speed—the
tabs will automatically retract to their normal running positions.
(Note that, for most activities, Single Tab AutoLaunch
is sucient.)
Crossover speeds are pre-set, but may be adjusted from the
Ballast/Tab Settings page. The crossover speed is the speed
at which the boat no longer needs assistance reaching a
fully-planed position. There is only reason the user should ever
adjust crossover speed: if the boat’s normal operating weight
is consistently very light or very heavy. In such cases, the speed
can be decreased for light weight boats and increased for
heavier boats.
Adjusting the crossover speed will take some experimentation.
The goal is to get the boat on plane quickly and without causing
any spray. If your boat will be heavily weighted with persons/
ballast for any consistent period, increase the crossover speed to
keep the tabs in the down (deployed) position longer. You can raise
crossover speed by tapping the + next to the tab(s) you wish to
increase.
If you plan to consistently run the boat without ballast or with
only a few people, decrease the crossover speed to pull the tabs
up earlier. To decrease the crossover speed for a particular tab
(center tab or Surf tab), tap the - next to that tab.
To Next Page
Loading...
Need help?
General
