2021 OWNERS MANUAL / 132
BALLAST
To fill the ballast tanks, touch either FILL ALL (Drive Mode) or tap in the
ballast area to adjust individual ballast zones. Note that some models
feature four ballast tanks and some models feature three.
Tapping the ballast zone area will pull up the following screen:
From the ballast screen, users can fill or empty all ballast zones
by touching FILL ALL or EMPTY ALL. To pause the fill process, tap
STOP ALL. To adjust individual ballast zones, touch the UP or DOWN
arrows at the top or bottom of the ballast zone to be filled or emptied.
Quickly fill or empty all
tanks to 100/0 percent
Individual tank
settings, tap to open
sliders
Alternatively, you may slide your finger along the ballast progress bars
to initiate or adjust ballast zones and to set custom fill levels.
ADJUSTING TABS
Tabs allow you to precisely dial in your wakes and waves by sculpting
the water as it leaves the hull bottom. Tap the tab area to adjust
individual tabs.
Make adjustments to each tab by touching the up and down arrows or
by sliding your finger up or down in the slider bar.
Tap this area to display
the tab adjustment
screen
2021MCOwnerManualFINAL.indd 132 8/26/20 1:52 PM
To Next Page
Loading...
Need help?
General
