2021 OWNERS MANUAL / 88
CRUISING
The dual screen dash simplifies cruising to and from the best riding
spot on the lake by allowing operators to easily get the boat’s ballast
and tabs settings prepared for a set.
Heading Out:
To prepare the boat for a riding session on the way to your favorite
spot, navigate to Drive Mode. The boat will default to 28 MPH and
AutoLaunch Single will default ON. If necessary use AutoLaunch
Triple. Tap FILL ALL to start filling the ballast tanks.
Heading Home:
At the end of the day when it is time to empty the ballast tanks and
head home, navigate to Drive Mode. AutoLaunch Single will default
ON and speed control will default to 28 MPH. Tap EMPTY ALL to
drain the ballast tanks. If necessary turn AutoLaunch Triple ON to
assist the boat to plane. Navigating to Drive Mode will always cancel
any active Tow Mode profiles, but will not drain the ballast tanks.
AutoLaunch Crossover Settings
AutoLaunch is the logic software that automatically deploys and
retracts the Gen 2+ tabs. When turned on, AutoLaunch automatical-
ly deploys either one, or all three of the tabs to push the boat up to
plane faster. As the boat accelerates and reaches its approximate
planing speed, called the crossover speed, the tabs will automati-
cally retract to their normal running position. Crossover speeds are
pre-set but can be adjusted on the Ballast and Tab Settings page.
The crossover speed is the speed at which the boat no longer needs
assistance planing out. The only reason to adjust the crossover
speed from the factory preset is if the boat’s normal operating
weight is consistently very light or very heavy. In this case the speed
can be decreased for light weight and increased for heavier loads.
Adjusting the crossover speed will take some experimenting. The
goal is to get the boat to plane quickly without causing any spray.
If your boat will be consistently heavily weighted with persons and
ballast, increase the crossover speed to keep the tabs down longer.
Increase the crossover by tapping the UP arrow next to the tab(s) to
be increased.
If the boat will consistently be run without ballast or with only a few
people, decrease the crossover speed to pull the tabs up earlier.
To decrease the crossover speed for a particular tab (center tab or
Gen 2+ tabs), tap the down arrow next to that tab.
2021MCOwnerManualFINAL.indd 88 8/26/20 1:51 PM
To Next Page
Loading...
Need help?
General
