same cleaning and care. (See Care and Maintenance upholstery
information in this Owner’s Manual.) Removable cushions should
also be stowed in storage when the boat is underway unless they
are snapped into position. Failure to stow or snap removable
cushions could result in the cushion being lost overboard.
Another attractive feature on some boat models is the folding arm
rest, normally found in the bow section. These arm rests are padded
with durable upholstery, which requires the same type of care as
all of the boat’s upholstery. (See Care and Maintenance upholstery
information in this Owner’s Manual.)
GAS ASSISTED SEAT LIFT
Models
XT20, XT21, XT22 XT23, X20, X26 and XStar, as an option
Purpose
Allow the helm seat to raise and lower ~3” to accommodate dierent
operator seat height preferences.
Location
Helm Seat
Operation
Lift the handle on the seat pedestal located on the outboard side of
the pedestal (circled in red). To raise, lift handle and remove body
weight and the seat will extend up. To lower, lift handle while apply-
ing weight to the seat to compress the gas assisted mechanism
inside. Release handle between the topmost and lowest position to
set and hold the seat height.
Troubleshooting
If the gas assisted seat lift will not operate properly, take the boat to
an authorized MasterCraft dealer for repair.
2021MCOwnerManualFINAL.indd 307 8/26/20 1:53 PM
To Next Page
Loading...
Need help?
General
