MasterCraft ProStar 190 - Page 71

BALLAST CONFIGURATION
 This is used to set the ll and
empty times for the Jabsco ballast
pumps. They can be adjusted by
pressingtheENTERbuttonandus-
ing the UP and DOWN buttons.
HOME MENU[EnableorDisable]
ABOUT VIPER
 Givesyouthecurrentsoftware
revision on the boat.
FEATURE UNLOCK
There are two ways to unlock a
newfeature.Inbothcases,youwill
needtogototheMedallionwebsite
[www.medallioinis.com] to retrieve
the unlock code.
Step1: Get the SERIAL NUMBER
from your system by going
toeitherABOUTVIPER or
FEATURE ENABLE in the
setup screens.
Step2: If using the IMPORT in
setup, copy the le to a
USBFlashDriveandpress
theIMPORTbuttontoread
thelefromtheUSBFlash
Drive.
Step3: If using the FEATUREEN-
ABLESETUP,youwillneed
to select the feature to be
unlocked.
Step4: Enter the unlock code to
enable the feature.
ALARMS AND WARNINGS
Engine TempisawarningreceivedfromtheengineECM.Seead-
ditionalinformationunderTemperatureGaugeintheInstrumentsand
GaugessectionofthisOwner’sManual.
Low Batterywillappearwhenthebatteryfallsto10.5volts.
MasterCraft 2012 Owners Manual • Guide to Individual Models • Page 2-44