STARTING AND BASIC OPERATION
11-3
Reverse: Raise the lifter ball under the lever knob and briskly pull the control lever back into the 45 degrees of
travel. Throttle movement will begin after 45 degrees.
Once the shift has been completed, continue to move the control lever slowly in the desired direction to
increase speed.
Note: When shifting from forward to reverse or reverse to forward, be sure to stop the control lever in
the neutral position and allow the engine to fall between 600-800 RPM before completing the shift.
Underway
If the oil pressure gauge indicates low or no oil presssure, stop and check the oil level. If the temperature gauge
indicates overheating, stop and check the raw water impeller for blockage. DO NOT operate the boat until the
cause for the warning has been found and corrected.
Stopping
Step 1: Slowly bring the control lever to the neutral position. If the boat has been driven for a long period of time
or at high speed, allow the engine a 2-3 minute cool-down period at low idle (600-800 RPM).
Step 2: Turn the ignition key to the OFF position to stop the engine.
Step 3: If any problems were encountered during operation, have the boat inspected by your MasterCraft dealer.
Request any necessary repairs before operating again.
Continued operation after the warning light has illuminated
may cause severe engine damage. This will void your warranty.
To Next Page
Loading...
Need help?
General
