225
/
2023 OWNER’S MANUAL
drain plug is on the centerline of the transom. Sea strainers are
located in front of the engine and can be accessed by removing
the transmission cover on all engine models. Scuppers, where
equipped, are located on the lowest point of the deck, under the
rear seats. Bilge pump-out locations are on the side of the boat.
Depending on the model, the pump-out may be on the bow or the
gunnel. See Guide to Individual Models in this Owner’s Manual to
determine the location of bilge pump-out. (They are often adjacent
to ballast overflow/vents.) Pump-outs should never be obstructed.
The bilge system operates automatically, but can be manually
controlled by a digital switch in the accessory page of the Dual
Screen Dash. The bilge pumps on all V-drive models will be in the
automatic mode when the ignition key is turned ON. Some models
may have two (2) switches, one for the forward bilge and one for
the aft. In these instances, the switches will be marked on the
screen. The manual and automatic bilge discharge system is never
completely OFF. When in the automatic (default) position, a sensor
alerts the system to discharge water from the bilge area.
Boat operators are advised to leave the switch in the automatic
position, unless there appears to be excess water in the bilge as
viewed through the center plate. In that event, the bilge pump can
be manually activated by turning the bilge pump switch to the
manual ON position. Return the switch to the automatic position
when finished emptying the bilge. Leaving the switch in manual
mode can result in damage to the pump and may not be covered
by warranty!
Return the bilge switch to automatic any time it has been turned to
manual to remove water from the bilge. Operators should monitor
the water level through the center drain and ensure that the bilge
pump(s) does not continue to operate after the bilge is emptied.
Note that a small amount of water in the bilge is acceptable,
except when winterizing the bilge system. Failure to follow
instructions may result in damage to the bilge system, which may
not be covered under warranty!
Drain plugs should be loosened and removed when the boat is
out of the water to allow additional drainage of the bilge system.
Always ensure that the transom drain plugs have been tightened in
place prior to launching the boat into the water. Failure to do so can
result in water intruding and overwhelming the system, sinking
the boat.
To Next Page
Loading...
Need help?
General
