MasterCraft X26 User Manual

CLAMPING BOARD RACK
OPERATION
Models
All X and XT Series models equipped with a ZFT4 or ZFT7 tower.
Purpose
Board racks use clamping force to hold surf and wake boards
firmly in place, up on the tower, out of the way of operators and
passengers in the boat.
Location
Swiveling racks are mounted midway up the ZFT4 and ZFT7 towers.
Operation
Board racks are operated by a black and red lever system on the
backside of the rack. To open the clamp press down on the red
release button. The clamps will open. To clamp the board racks,
press up on the clamp lever until it locks into place, firmly holding
the board in place.
2021MCOwnerManualFINAL.indd 273 8/26/20 1:53 PM

MasterCraft X26 Specifications

General

Length Overall	26' 5"
Engine	Ilmor 6.2L
Ballast Capacity	4, 300 lbs
Beam	102 in
Draft	30"
Engine Options	Ilmor 6.2L, Ilmor 7.4L
Tower	ZFT4
Seating Capacity	18