MasterCraft X26 User Manual

Step 5
Thoroughly clean and apply a light coat of waterproof marine multi-
purpose grease to the splined area of the shaft and propeller.
Step 6
Align the splines and carefully install the propeller onto the shaft.
DO NOT FORCE THE PROPELLER INTO PLACE. If necessary, gently
tap the propeller into place with a rubber mallet.
Step 7
Install the propeller nut and tighten it into place to 50-ft-lbs with a
torque wrench.
Step 8
Install a new cotter pin and bend the ends around the shaft to lock
the propeller on the shaft.
2021MCOwnerManualFINAL.indd 391 8/26/20 1:54 PM

MasterCraft X26 Specifications

General

Length Overall	26' 5"
Engine	Ilmor 6.2L
Ballast Capacity	4, 300 lbs
Beam	102 in
Draft	30"
Engine Options	Ilmor 6.2L, Ilmor 7.4L
Tower	ZFT4
Seating Capacity	18