system that lifts the cover up so that snow or water drains o the
side rather than pooling on top of the cover. Anti-pooling covers use
a drawstring system to lift the canvas mooring cover up towards the
tower. The anti-pooling cover is designed to be used in conjunction
with anti-pooling poles during long-term storage, or on long road
trips. Poles are required when trailering the boat for trips lasting more
than one (1) hour, at speeds over 70 MPH. Poles are also required for
use with the mooring cover for long term and seasonal storage.
Location
Mooring covers mount over the boat and use ratcheting straps to
secure them snugly around the boat. The anti-pooling system on under
tower covers loops over the tower tow point and is secured in place by
pulling on the drawstring mounted to the aft portion of the canvas.
Operation
To install a boat cover with the anti-pooling drawstring:
1. Cover the bow and the forward portion of the cockpit with the
canvas designed to fit the bow.
2. Continue covering the boat from bow to stern until you reach the
windshield. Ensure that the windshield door is closed. Continue
covering the boat.
3. When you reach the tower base, mount the neoprene anti-pooling
loop over the tow point on the tower.
4. Buckle the buckles on both sides of the tower and ensure that the
velcro is secured around the tower legs.
5. Cover the rest of the boat to the transom. Pull the canvas down
below the rubrail on XT and NXT models and use the ratcheting
straps to secure the cover onto the boat. Ratchet the straps until
2021MCOwnerManualFINAL.indd 287 8/26/20 1:53 PM
To Next Page
Loading...
Need help?
General
