155
/
2023 OWNER’S MANUAL
FUEL MANAGEMENT
The fuel management software in MasterCraft boats directly
connects the boat operator to the management of their fuel.
This system collects precision information on fuel flow levels from
the engine controller. It then calculates and displays the amount of
fuel remaining based on engine activity and the usable size of the
fuel tank.
As a safeguard, there is a back-up low fuel sensor that signals any
discrepancies between the computer and the actual amount of
fuel in the tank.
Using Fuel Management Sofware
Upon keying the boat on, the touchscreen display will ask the
operator if fuel has been added to the boat.
Tap NO on the screen to close the fuel management system, or tap
YES to display the fuel level entry page. The operator can input the
amount of fuel added, or tap the FULL button to indicate that the
tank has been filled completely. Fuel levels will be displayed next to
“Amount” at the top of the screen.
Press SAVE to exit to the menu screen.
Should an operator input the wrong amount of fuel on the fuel
entry page, there are several fail-safes in place. To immediately
correct an input error, navigate to the Main Menu tab and scroll to
and tap FUEL MANAGEMENT. This will re-open the fuel level entry
page. Use the keypad and the +/- button to adjust to the correct
amount of fuel. Use a positive value if more fuel needs to be
entered, or use a negative value if too much fuel was entered.
When the fuel management system senses that fuel is getting
low it will display a low fuel warning on the screen. When this
warning is displayed, the boat will be able to run unballasted for
approximately twenty (20) minutes (without any ballast) before
running out of fuel. Empty all ballast tanks and immediately
proceed to a fueling station before any further activity.
Continuing to operate the boat with low fuel levels could leave
users stranded oshore.
To Next Page
Loading...
Need help?
General
