2023 OWNER’S MANUAL
/
170
COURSE MANAGER– ALL
SLALOM AND JUMPING EVENTS
On the 3 Event screen, touch the Auto Detect / No Course Active
button, and the Course Manager screen will appear.
NOTE: Always highlight a course on the list page before mapping
a new course. When mapping a course, the program assigns the
mapping to whatever name is highlighted on the course list.
When auto detect is active, you do not have to select an active
course. The 3-Event head unit automatically starts the course and
timers based on your GPS location when you enter a course. If auto
detect is not active, you have to manually select a course you want
to follow.
Course Mapping Instructions
Step
Action
1
Highlight a course to be mapped, then touch .
2 Press Start Gate to begin mapping the course.
For Slalom, press the Start Gate button when the GPS
puck crosses the start gate.
For Jump, press the Start Gate button when the Ski
Pylon crosses the start gate.
3 Press End Gate to stop the mapping.
4 If necessary, touch Cancel to cancel the current
mapping and return to the course list.
Pull type is the amount of “pull” felt by the
skier as the boat adjusts to maintain the
set speed.
A: Slower engine response out
of the buoy
B: Moderate engine response
C: Faster engine response
1: Softer pull behind the boat
2: Moderate pull behind
the boat
3: Harder pull behind the boat
In the On position, the system will react
sooner to both increase and decrease in
speed deviation.
Used for trick setting or additional throttle
when entering the first gate.
To Next Page
Loading...
Need help?
General
