2023 OWNER’S MANUAL
/
244
Troubleshooting
• If the switch(es) is/are unresponsive, check the main circuit
break panel to determine if the circuit has tripped. Reset the
circuit and try the switch again.
• If the circuit continues to trip, bring the boat to an authorized
MasterCraft dealer for repair.
If the boat does not respond as noted in the above instructions,
turn OFF the switch and do not use the attitude adjustment
function until the system has been checked by authorized
MasterCraft dealer. Malfunction can result in loss of control of
the boat.
plate(s).
Never use the attitude adjustment plate(s) to board or assist
in boarding the boat. Sharp edges can cut individuals, causing
potentially serious bleeding. Damage to the plate(s) from people
using it to board the boat is not covered under warranty.
Additional Special Attention
Care should also be taken when backing up the boat in shallow
water, removing boats from the water on steeply pitched access
areas, or backing up with the boat on a trailer. The attitude
adjustment plate(s) does not fold or retract, and it may require
additional clearance to avoid damage to the plate(s).
Resulting damage from failure to follow instructions is not
covered under warranty.
Care must be taken to ensure that there is always sufficient
clearance around the attitude adjustment plate, whether it is in
the water or out, particularly on a trailer. The attitude adjustment
plate(s) extends beyond the boat transom and is not foldable or
retractable. Damage to the plate(s) from failure to allow sufficient
clearance is not covered under warranty.
To Next Page
Loading...
Need help?
General
