257
/
2023 OWNER’S MANUAL
The platform must be raised and locked into position for
transportation of the boat, as well as use of the platform while
boating. Leaving the platform down may result in damage to the
boat transom during transport that will not be covered by
the warranty.
Securing the Platform
Lift the platform to an angle of approximately 20 degrees from
the boat. Lightly push the platform (do not shove nor jam) toward
the transom to allow the platform to set in place.
Verify that the platform is in the locked position and will not fall
down. Failure to verify that the platform is locked may result in the
platform falling while someone is on it and could result in injury.
Insert one (1) safety hinge pin into each platform bracket.
The platform must be raised and locked into position. No one
should be allowed on the platform until the platform is securely
locked in place and the engine is OFF. Failure to do so may result in
serious injury or death!
kind of manual support to the platform at the time of releasing
the bracket, and then slowly lower the platform into place for
towing or storage.
NOTE: The surf tabs may also need to be lowered prior to lowering
the swim platform.
Folding Down the Platform
Remove the safety hinge pins in each swim platform bracket.
Begin by lifting the platform about four (4) inches upward while
easing the platform away from the boat transom. This will allow
the platform to move freely on the hinge.
NOTE: Ensure there is no tightness while the swim platform is
being folded. There should be no binding during this action.
To Next Page
Loading...
Need help?
General
