275
/
2023 OWNER’S MANUAL
Operation
The design of the glove box varies depending on the model. All
have a closable lid. To open the glove box lids that feature a
recessed button, simply push in on the button. A twist knob will
pop up. Twist the knob to disengage the lid from the box.
Special Attention
Glove box lids should always be closed and latched any time the
boat is in operation. While the boxes are water resistant, if the lid
is not latched securely water can intrude and cause damage to
anything inside the glove box. MasterCraft is not responsible for
such damage. Any items placed in the glove box that cannot or
should not become wet should be placed in water tight containers
before placing them inside the glove box.
Troubleshooting
Any time the lid will not close and latch properly, see an authorized
MasterCraft dealer. If it is not properly closed, damage could occur
to the lid.
HEATER
Models
All models, as an option.
Purpose
Warmed air from an electrically powered heater box will be blown
from vents within the boat deck, to keep occupants warm.
Location
Heater vent locations vary by model, but all are located within the
cockpit. They typically reside in the driver’s floor, either side of the
cockpit in the cup holder inserts, and/or on the observer dash near
the glove box. A heater tube and vent is typically installed near the
floor.
Operation
The heater is controlled through the dual screen dash. It has two
settings HIGH and LOW. Tap the heater button to turn the heater
ON LOW. Tap the button again to turn the heater ON HIGH.
Tapping the heater button again turns it OFF. The heater can only
be operated with the engine ON. This prevents excessive
battery drain.
To Next Page
Loading...
Need help?
General
