277
/
2023 OWNER’S MANUAL
or if the circuit continues to trip, take the boat to an authorized
MasterCraft dealer.
ANCHOR
Models
All models (excluding ProStar) have a bow cleat for securing
anchor lines. Anchors are optional on all models.
Purpose
The anchor allows the boat to be temporarily moored in relatively
shallow water. Note that standard equipment does not include the
line for the anchor. This is because needs will vary considerably by
location of the body of water. The general rule of thumb is that the
boat owner should purchase anchor line from a marine aftermarket
company at a length about three-to-four (3-4) times the depth of
the body of water in which the boat will be moored.
Location
Some models are equipped with anchors, and there will be a
designated storage area or stowage location on the boat, normally
in the forward area of the bow. Check with your dealer if you are
Operation
To turn the seat heater(s) on, navigate to the accessories page
on the dash mounted touchscreen. Tap seat heat button to turn
the seat ON. The button will change colors to show that the seat
heater is ON. Note that the seat heater will only operate with the
engine is running.
Special Attention
Do not leave open food, sun tan oil, or other materials on the
seats if the seat heat function is ON. Although the heat does not
exceed a temperature at which skin can touch without burning, the
additional heat could cause some types of food or other materials
to melt, causing a stain or damage that is not covered under
warranty.
Do not leave unattended, open food or other materials that could
melt, on a seat equipped with a seat heater that is or will be turned
ON. The additional heat could cause melting, resulting in a stain or
other damage that is not covered under warranty.
Troubleshooting
If the seat heat system does not work when the switch is ON,
check at the main circuit breaker panel to ensure the circuit has
not tripped. If so, reset. If the seat heater(s) still does not work
To Next Page
Loading...
Need help?
General
