MasterForce 208-5012 User Manual

OPERATION and MAINTENANCE MANUAL
BEFORE OPERATING THIS TOOL, ALL OPERATORS SHOULD STUDY THIS MANUAL TO
UNDERSTAND AND FOLLOW THE SAFETY WARNINGS AND INSTRUCTIONS. KEEP THESE
INSTRUCTIONS WITH THE TOOL FOR FUTURE REFERENCE. IF YOU HAVE ANY QUESTIONS,
CONTACT YOUR REPRESENTATIVE OR DISTRIBUTOR.
208-5012
CLIPPED HEAD FRAMING NAILER

MasterForce 208-5012 Specifications

General

Brand	MasterForce
Model	208-5012
Category	Nail Gun
Language	English

Summary

SAFETY INSTRUCTIONS

SERVICE

AIR SUPPLY AND CONNECTION

LOADING TOOL

OPERATION

MAINTAINING THE TOOL

AIR SUPPLY AND CONNECTIONS

FITTINGS

Details installation of male plugs for air hose connections.

HOSES

Specifies minimum working pressure and quick disconnecting fittings for air hoses.

SUPPLY SOURCE

Recommends clean regulated compressed air; warns against oxygen or combustible gases.

REGULATOR

Requires a pressure regulator for safe operation, set between 0-125 p.s.i.

OPERATING PRESSURE

Advises against exceeding maximum operating pressure to prevent tool wear.

FILTER

Explains the importance of a clean filter for performance and preventing wear.

LUBRICATION

COLD WEATHER OPERATION

PRODUCT SPECIFICATIONS

DEPTH ADJUSTMENT

LOADING

TOOL OPERATION

CONTACT TRIP OPERATION

Explains two methods: single fastener placement and rapid fastener operation.

SEQUENTIAL TRIP OPERATION

Details operating the tool by depressing the contact trip then pulling the trigger.

TOOL OPERATION CHECK

MAINTAINING THE PNEUMATIC TOOL

REPLACEMENT PARTS

Recommends using MENARDS replacement parts and avoiding modified or incompatible parts.

ASSEMBLY PROCEDURE FOR SEALS

Advises cleaning and lubricating internal parts and pivots during repair.

AIR SUPPLY-PRESSURE AND VOLUME

Stresses the importance of adequate air volume and identifies causes of restricted airflow.

TROUBLE SHOOTING