6
WARNING:
WARNING:
WARNING:
WARNING:
Keep
Keep
Keep
Keep the
the
the
the extension
extension
extension
extension cord
cord
cord
cord
clear
clear
clear
clear of
of
of
of the
the
the
the working
working
working
working area.
area.
area.
area. Position the cord so
it will not get caught on the workpiece, tools or
any other obstructions while you are working
with the power tool.
Make sure any extension cord used with this
tool is in good condition. When using an
extension cord, be sure to use one of heavy
enough gauge to carry the current the tool w
ill
draw. An under
sized cord will cause a drop in
line voltage resulting in loss of power and
overheating.
The table at right shows the correct size to use
according to cord length and nameplate ampere
rating. If in doubt, use the next heavier gauge.
The smaller the gauge number the heavier the
cord.
Be sure your extension cord is properly wired
and in good condition. Always replace a
damaged extension cord or have it repaired by a
qualified electrician before using it. Protect your
extension cord from sharp objects, excessive
heat and damp or wet areas.
Use a separate elec
trical circuit for your power
tools. This circuit must not be less than 14
gauge wire and should be protected with either
a 15 A time delayed fuse or circuit breaker.
Before connecting the power tool to the power
source, make sure the switch is in the OFF
position and the power source is the same as
indicated on the nameplate. Running at lower
voltage will damage the motor.
MINIMUM
MINIMUM
MINIMUM
MINIMUM GAUGE
GAUGE
GAUGE
GAUGE (AWG)
(AWG)
(AWG)
(AWG)
EXTENSION
EXTENSION
EXTENSION
EXTENSION CORDS
CORDS
CORDS
CORDS (120
(120
(120
(120 V
V
V
V use
use
use
use only)
only)
only)
only)
Amperage
rating Total length
More
than
Not
more
than
25'
(7.5 m)
50'
(15 m)
100'
(30 m)
150'
(45 m)
0 6 18 16 16 14
6 10 18 16 14 12
10 12 16 16 14 12
12 16 14 12 Not Applicable
EXTENSION
EXTENSION
EXTENSION
EXTENSION CORD
CORD
CORD
CORD SAFETY
SAFETY
SAFETY
SAFETY
!
!
!
!
SPECIFICATIONS
Rating 120V, 60Hz
Power 6.5Amp
Collet chuck capacity 1/4", 3/8"
No load speed (RPM) 10,000 - 32,000/min
Net weight 4.4lbs
To Next Page
Loading...
