EasyManua.ls Logo

MasterMover MasterTug MT30/2000+ PAS - Charging; External Charger Procedure; Internal Charger Procedure

Default Icon
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Charging
17
Charging
Charging with the External Charger
1. Take the machine to the recharging bay. Switch the machine
OFF and remove the key.
2. Make sure the charger is switched OFF.
3. Locate the battery and pull out the machine plug from the
battery pack connector (some models may have the plug in a
separate compartment on the outside of the machine).
4. Push the charger plug firmly into the battery pack connector.
5. Switch the charger ON.
6. Check that the charger indicator light shows that it is ON.
7. Leave it on charge until the charger indicator shows “Full” - this
could take several hours. The length of time depends on the
model of your machine, the type of charger, the battery pack
capacity and the level of discharge when you start charging.
Note: Following the above procedure will prolong the battery life.
8. Switch the charger OFF and unplug the charger connector from the battery pack.
9. Make sure the machine is switched off and then plug the machine connector into the
battery pack.
10. Close the compartment (where applicable). You can now resume normal use.
Charging with the Internal Charger
1. Take the machine to where there is a convenient mains socket. Switch the machine OFF
before charging and remove the key.
2. Locate the mains plug and extend the mains lead, connect it to a mains supply and switch
ON.
3. Check that the charger indicator light(s) show that it is ON. Leave it on charge until the
charger indicator shows “Full” - this could take several hours. .The length of time depends on
the model of your machine, the type of charger, the battery pack capacity and the level of
discharge when you start charging.
Note: Following the above procedure will prolong the battery life. Always charge with the
battery lid open.
4. Switch the mains supply OFF, unplug the mains lead and reverse the process given in point 2,
making sure the machine is switched OFF.
5. Put the cables carefully inside the machine, so that they will not be trapped.
6. You can now resume normal use.
CAUTION: CHARGER INSTRUCTIONS
Failure to follow the above instructions will result in the charger not resetting
this can create problems with future battery charging.

Related product manuals