Do you have a question about the MATALA Biofilter 10 and is the answer not in the manual?
Connect grey water to the short side with a single 75mm inlet hole.
Purified water connects to the lower hole with two 75mm outlets.
Release purified water into stone coffin or HS infiltration systems.
Spreader tube in biomodule, covered with ground cloth and gravel.
Expand area and add drainage pipes for difficult soil absorption.
An accessory to manage warm water temperature affecting the biohud.
Connect two filters in parallel to increase capacity to 600 litres/day.
Includes a 32mm PEM connector suitable for 32mm PEM hose.
Technical graph showing pump head versus flow rate.
Outgoing air exits via housing pipe trunk or lid hole, ideally high.
Emphasizes ventilation for air exchange and biodegradation at both ends.
Microbial growth is sensitive to poisoning from chemicals, detergents, oil, etc.
Large amounts of greasy dishwater may require more frequent filter cleaning.
Deteriorated flow or dirty upper parts indicate cleaning is needed.
Filters are arranged: 2 green, 2 blue, and 4 grey from inlet to outlet.
Clean filter elements annually by shaking them over a compost.
Residual sludge should be composted in a latrine compost.
Shake off 90% of sludge from filters over compost; return filters to ensure purification.
Compost sludge in a latrine compost for 6 months for full degradation.
Avoid frequent cleaning as it reduces microbial growth and purification results.
Drain biofilter if freezing risk stops flow; insulate extra for winter use.
| Category | Water Filtration Systems |
|---|---|
| Type | Biofilter |
| Filter Media | Matala Filter Media |
| Application | Aquaculture |
| Biofilm Support | Excellent |
| Surface Area | 10 m² |
Loading...