Matchless Leanline III TC

To Next Page

To Previous Page

LEANLINE III TC

III TC Lo

SECTION TH

Place a row of 5 'B' ~oals as shown. Ensure the fronts of

these coals are supported by the front coal and the rear

edges rest on top of the rear matrix.

Note: These coals ~ust be position on top of the rear

matrix and

not into fhe valleys and no coals should be

placed on top of the burner.

Fig.5x

lJ31·16

• Place five (3 'A' and 2 'B') coals as shown. Ensure

that the 'B'

c~.1

is positioned so that the corner,

which has an a1gle of approximately 90

located

into the corner

of the appliance up against the rear

and side of the appliance. The

short side of the

'A'

coals

should be position

against the rear

of the

appliance and rebt on top of the rear matrix.

Fig.6x

• Place four (2 'A' and 2 'B') coals on top of the rear

matrix as Shown

• Place three (2

,1,

and 1 'B') coals on top of the rear

matrix as shownT

• Place the 2 remalning 'A' coals as shown.

1~3150

58201

Users Instructions

Matchless Leanline III TC - Page 4