PRODUCT INFORMATION:
SPECIFICATIONS:
Page 2
OPERATION AND USE:
IMPORTANT:
1. Press the rear On/Dim/Off button.
2. Press again to dim to half power. Hold to turn off.
3. Plug the 12V charger adaptor to the wall socket,
and connect to the light bar.
Turn on the power and start the charging.
4. Suggest charging every three months
when the light bar is not in use.
5. For first time use, charge your light bar for 3 – 4 hours
before use, and allow 3 – 5 cycles of charging
and discharging the battery to optimum performance.
Operation
Status of Charger
(Yellow LED)
Status of Battery
(Red LED)
Notes
Normal Operating
Normal Charging
Low Battery
Faulty Charging
OFF
ON
OFF
BLINK
OFF
OFF
BLINK
OFF
Activate 20 minutes prior shut down
Battery faulty
• It is not recommended to operate the light-bar
exceed the temperature specification.
• The life expectancy of the battery is approximately
500 cycles, at which time the replacement of the battery
pack assembly is recommended.
LED INDICATOR:
1604091-14
ULTRA THIN RECHARGEABLE
LED INSPECTION LIGHT
UTL10A
Powerful design. 400 lumens on high and intuitive
On/Dim/Off button on back of light.
Magnetic. Powerful 20lbs. neodymium magnet
attaches to movable bracket or 1/4" threaded boss
on the light’s handle and allows for use of other
custom attachments.
Dependable. Nearly indestructible design.
Light Source
Light Output Brightness
Rated Input Voltage
Rated Current Consumption
Operation Voltage
Battery
Charger
Operational
12 White LED
400 lumens max
DC 12 V
500 mA
5V – 16V
3.7V 2400 mAh Rechargeable
Li-Polymer Battery
Built-in high efficiency
charger module
Multi-Mode Switch
(power on/off, low/high)
3 hours at high brightness
10 hours at low brightness
Charge time 3 hours
Mechanical Construction
Power Adaptor
Operation Temperature
Storage Temperature
Size
Weight
Nylon Glass Filled Housing
Elastomer Overmolded Perimeter
Polycarbonate Clear Lens
12V 0.5A Universal Charger Adaptor
+23°F to +113°F
-4°F to +158°F
12" L x 1.25" W x 0.5" D
115g
To Next Page
Loading...