Matelec FSW-12220 User Manual

MATELEC AUSTRALIA. P 1800 281 282. F 1300 281 282
INFO@MATELECAUSTRALIA.COM.AU. WWW.MATELECAUSTRALIA.COM.AU
SPECIFICATIONS
INSTALLATION
1. Choose a suitable mounting location, ie. Avoid areas subject to heavy shading or interferance by
other light sources eg. Street Lights etc.
WARNING: Before drilling, ensure the area is clear of services eg. Water/Gas pipes, electric cables etc
.
3. Fix unit to wall/ceiling and bring cable through rear bung
WARNING: Isolate power supply before commencing wiring
4. Use the insulation caps provided, to cover screw heads
FSW-12220 HDAD/SUNSET SWITCH
Supply Voltage 240V ± 10%
Frequency 50Hz
Power Consumption 2W
Operating Temperature -10 to +60°C
Restrictive Maximum Load Rating 20amps
Inductive Maximum Load Rating 3600VA
Fail Safe Position ON
Lux On/Off Adjustable:
Time On (hrs) Adjustable
(via jumper)
20
200
+
_
6. Once power is applied, lights will come on for a 20sec warm-up period before they are ready for
use.
7. Test by covering lens completely using the box supplied. Please Note: The unit has a built in delay
to avoid nuisance switching and may take up to 20 secs to switch once sunset is stimulated.
9. To ensure photocell operates as a conventional unit, please ensure the time adjustment setting is

Matelec FSW-12220 Specifications

General

Brand	Matelec
Model	FSW-12220
Category	Switch
Language	English

Summary

Specifications

Supply Voltage

Specifies the required input voltage range for the device.

Frequency

Details the compatible AC power frequency for the sunset switch.

Power Consumption

Indicates the electrical power drawn by the device during operation.

Operating Temperature

Defines the ambient temperature range within which the unit will function.

Restrictive Maximum Load Rating

Specifies the maximum resistive load the switch can handle.

Inductive Maximum Load Rating

Specifies the maximum inductive load the switch can handle.

Fail Safe Position

Describes the output state of the device in the event of a system failure.

Installation Instructions

Choose Mounting Location

Select an installation site avoiding shade or interference from other light sources.

Remove Fixing Screws and Lens

Detach the device's lens by unscrewing it from the main housing.

Mount Unit and Route Cable

Securely fix the unit to a surface and pass the power cable through the rear bung.

Cover Screw Heads with Caps

Use provided insulation caps to cover all exposed screw heads for safety.

Connect Cables and Refit Lens

Wire the device to the terminal strip and then reattach the lens assembly.

Power On: 20-Sec Warm-up

After power application, the unit performs a 20-second warm-up before activation.

Test by Covering Lens

Verify functionality by completely covering the lens, noting a built-in delay.

Factory Default Settings

Outlines the pre-set light level and time-on configuration.

Set for Conventional Operation

Adjust time setting to 'infinity' for standard sunset/sunrise switching.