figure below), if you want to change the OCP setting value, you can lightly press the current window number
corresponding to the CH1/CH2 current adjustment knob Flashing, turn the knob left and right to change the setting
value. When in the setting state, lightly press the knob to change the setting position (CH1 current adjustment knob
sets CH1 OCP, CH2 current adjustment knob sets CH2 OCP). If you want to turn on or off the OCP function, you can
lightly press the CH1/CH2 voltage adjustment knob and then turn the knob left and right to change the fixed value
ON/OFF (ON is to open the OCP function, OFF is to close the OCP function, the voltage adjustment knob of CH1
sets the OCP of CH1 The function is turned on/off, and the CH2 voltage adjustment knob sets the OCP function of
CH2 on/off).
2. OVP setting: Long press the CH1/CH2 voltage adjustment knob to enter the OVP function setting (as shown in the
figure below), if you want to change the OVP setting value, you can lightly press the voltage window number
corresponding to the CH1/CH2 current adjustment knob. Flicker: Turn the knob left and right to change the setting
value. In the setting state, press the knob to change the setting position (CH1 voltage adjustment knob sets CH1
OVP, CH2 voltage adjustment knob sets CH2 OVP). If you want to turn on or off the OVP function, you can lightly
press the CH1/CH2 current adjustment knob and then turn the knob left and right to change the fixed value
ON/OFF (ON is to open the OVP function, OFF is to close the OVP function, the current adjustment knob of CH1 is
set to CH1 OVP The function is turned on/off, and the current adjustment knob of CH2 sets the OVP function of CH2
on/off).
3.OCP protection: When the output current exceeds the OCP setting value, the current window of this channel will
prompt "OCP" and turn off the output (as shown in the figure below). The CH1 and CH2 channels have independent
OCP settings and protection functions. The two channels are not related to each other, only the channel exceeding
the set value will be shut down, and the channel will continue to maintain the output state.
To Next Page
Loading...