initialize the IP settings, Password and System
Parameters of the DIRECT DOOR to factory defaults.
2. The Ethernet RJ45 connector is located just above the
terminal strip on the back of the Door Controller. Connect
the male RJ45 connector here in the event of the
DIRECT DOORs or the Ethernet connectivity option
being used for the PANEL DOORs.
Ethernet Cable
Standard DOOR Premium DOOR
Step 8: Mounting the Door Controller
Once all the connections have been completed it is time to
mount the door controller unit next to the access point such
as a door or turnstile as mentioned earlier.
Drill holes in the wall for insertion of the screws provided
with
the door controller. The holes are to be drilled in
accordance
with the following dimensions of the mounting plate of
the
door controller unit.
To Next Page
Loading...