Matrix DWS 1200 - Before Start-Up

26
WARNING: When using electric tools
basic safety precautions should always
be followed to reduce the risk of re, electric
shock and personal injury.
WARNING: Read all safety warnings and
instructions. Failure to follow the
warnings and instructions may result in electric
shock, re and/ or serious injury.
Save all warnings and instructions for future
reference.
The term “power tool” in the warnings refers to
your mains-operated (corded) power tool
or battery-operated (cordless) power tool.
4. Structure overview (B1)
1. Speed adjuster
2. Lock-on button
3. handle
4. Sanding pad cover
5. Aux-handle
6. Suction adjuster
7. Main switch
8. Dust outlet
9. Sanding paper
10. Sanding pad
Standard accessories
1. Sandpaper(x6)
2. Telescopic dust hose
3. Cloth bag
4. Carbon brush(x2)
5. Screwdriver
6. Hex key
5. Before start-up
5.1 unpacking
1) Open the packaging and carefully take out the
power tool.
2) Remove the packaging material as well as the
packaging / transport locks (if any).
3) Check the scope of delivery for completeness
and check the power tool and the accessory parts
for transport damage.
Note: Do not start the power tool if you notice
that parts are missing or damaged. Contact the
retailer where you purchased this power tool.
4) Store the packaging until the end of the
warranty period, if possible. Please dispose of
the packaging in accordance with environmental
regulations and take it to a recycling depot.
WARNING!
Neither power tools nor packaging
materials are toys!
Children must not play with plastic bags, foils
and small parts! Danger of swallowing and
suocation!
5.2 Sandpaper
Selection
1) The grain size of the sandpaper is specied on
its rear side. The smaller the specied number,
the coarser the graining.
2) Use sandpaper with coarse grain for rough
grinding, and sandpaper with ne grain for
nishing. We recommend sandpapers with
aluminium oxide, silicon carbide or other
synthetic abrasives.
3) If you can chose between sandpapers with
dierent graining, you should start with coarse-
graining sandpaper and complete the grinding
process with the nest possible graining. Thus
you will get good and smooth grinding results.
5.3 Fitting the Aux-handle (B1-1)
The machine must not be used without the Aux-
handle (5).
The additional handle can be secured in any of 2