EasyManuals Logo

Matrix EHD 1250-30 User Manual

Matrix EHD 1250-30
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #29 background imageLoading...
Page #29 background image
29
8. Starting up
Important.
To prevent all danger, the machine must only
be held using the two handles (6/8). Otherwise
there may be a risk of suering an electric shock if
you drill into cables.
8.1 Switching on and o (Fig. 1)
To switch on:
Press the control switch (4).
To switch o:
Release the control switch (4).
8.2 Hammer stop facility (Fig. 7)
The hammer drill has a hammer stop facility for
gentle initial drilling.
Turn the rotary switch for the hammer stop
facility (5) to position (B) to switch o the
hammer facility.
To switch on the hammer facility again the
rotary switch for the hammer stop facility (5) must
be turned back to position (A).
8.3 Rotation stop facility (Fig. 8 / 9)
The rotation function of the hammer drill can be
switched o for chiseling jobs.
To do this, turn the rotary switch (3) into position
A (see Fig. 8).
To switch on rotation facility again, turn the
rotary switch (3) into position B (see Fig. 9).
Important.
Please note that it is not possible to operate the
hammer drill with the hammer stop and rotation
stop facilities both active at the same time.
Important.
Only low pressure is required for hammer drilling.
Excessive pressure will exert an unnecessary force
on the motor. Check the drill bits at regular
intervals. Sharpen or replace blunt drill bits.
9. Replacing the power cable
If the power cable for this equipment is damaged,
it must be replaced by the manufacturer or its
aftersales service or similarly trained personnel to
avoid danger.
10. Technical data
Mains voltage: 220-240 V~/ 50 Hz
Power input: 1250 W
Idling speed: 800 rpm
Drilling capacity in concrete/stone (max.): 30 mm
Protection class: II /
Sound and vibration
Sound and vibration values were measured in
accordance with EN 60745.
L
pA
: sound pressure level 92,4 dB(A)
K
pA
: uncertainty 3 dB(A)
L
WA
: sound power level 103,4 dB(A)
K
WA
: uncertainty 3 dB(A)
The hammer drill is not designed for outdoors
use as specied I Article 3 of Directive 2000/14/
EC_2005/88/EC.
Wear ear-mus.
The impact of noise can cause damage to hearing.
Total vibration values (vector sum of three
directions) determined in accordance with EN
60745.
Hammer drilling in concrete
Vibration emission value a
h,HD
= 14,641 m/s
2
K uncertainty = 1.5 m/s
2

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Matrix EHD 1250-30 and is the answer not in the manual?

Matrix EHD 1250-30 Specifications

General IconGeneral
BrandMatrix
ModelEHD 1250-30
CategoryRotary Hammer
LanguageEnglish