10
Unpacking
Important.
Danger from missing parts.
Carefully take all the parts out of the box and
placethetoolonaflatworksurface.Check
that the contents are complete.
If there are any parts missing, do not use the
tooluntilallthemissingpartshavebeendeli-
vered and correctly installed. Failure to obser-
ve this warning may give rise to a considerable
risk of injury.
Do not throw the packaging material away
until you have carefully inspected the tool,
ensured that all the parts are fitted correctly
and you have started the new tool without any
problems.
Note:
If any parts are missing or damaged, do not
connect the machine to the power supply and
donotpresstheONswitchuntilallthedama-
gedormissingpartshavebeenreplacedand
installed correctly.
5. Description of symbols
Pay attention to all the signs and symbols
shownintheseinstructionsandonyourtool.
Make a note of these signs and symbols. If you
interpret the signs and symbols correctly, your
work with the machine will be safer and better.
Important.
Read the instructions for use before
starting the machine.
Wear safety goggles.
Wear ear protection.
Wear good quality, strong gloves.
Always use breathing apparatus
when machining materials which
generate dust.
End of life machines contain valuable
materials and therefore they should
not be placed in household waste.
Wewouldaskyoutoplayyourpartin
protecting resources and help protect the
environment by returning this machine to a
return point (if one is available) when it reaches
the end of its life.
6. Machine components (B1)
On/Off switch
2. Clockw./Counter-clockw.selector lever
3. Locking knob
4. Speed setting knob
5. Quick drill chuck 2-13 mm Ø
6. Drill/percussion drill switch
7. Depth stop
8. Power handle
9. Chuck
10. Chuck round section
7. Working with the drill
Clamp the bit in the chuck (9) securely and
firmly.
To switch the drill on, press the on/off switch
(1) and the machine will start.
To switch it off, release the switch (1) and the
machine will stop.
For continuous operation, press the on/off
s wi t c h (1) a n d t h e l o c k i n g b u t t o n (3 ) o n t h e
handle at the same time.
To switch off continuous operation (3), press
theon/offswitch(1)andthenreleaseitagain.
Device of protection class II
- Hold the device at the insulated handle
areas when you are performing work during
which the tool being used may hit concealed
power lines, or its own power cord. Contact
with a live line can also make device parts
made of metal alive and can cause an electric
shock.
themachineisstillrunning.
Warning when drilling into walls. Localise
electrical, water, and gas lines with a
detector.
To Next Page
Loading...