11
Electronic Speed Regulation
Increasing pressure on the on/off switch (1)
will cause the speed to increase.
You can preset the desired speed with the
setting wheel (4) in the on/off switch (1):
Turning in the “+” direction = increased speed
Turning in the “-“ direction = decreased speed
Handling the Quick Drill Chuck (5)
To insert a drill bit, hold the back section of the
drill chuck (5) and turn the front section (9) in a
clockwise direction (as seen from the handle).
Put the bit completely in and turnthefront
sectionofthedrillchuckfirmlytotheleft.
WARNING: Only use bits with
cylindrical, round shafts.
AuxiliaryHandlewithDepthGuide
The auxiliary handle makes it easier to apply
pressure when drilling and gives you a secure
grip when working.
To assemble, unscrew the wing bolt (10),
push the adapter over the drill chuck to the
fastening ring and tighten.
You can accurately set the depth of the drill
hole by using the depth guide (7). Put it into
the graduated hole that is provided and slide it
tothesamelengthasthetipofthebit.
Readthevalueinmmfromthescale.
Subtractthedepthofthedrillholefromthis
value.
Set this value on the depth guide (7) and
firmlylockthestoppositionwiththewingbolt
(10).
Switching between clockwise/counter-
clockwise rotation
IMPORTANT: Only press this switch
when the machine is at a standstill,
otherwise the machine may be
damaged.
For drilling and hammer drilling:
Set selector lever (2) to position “R” =
Clockwise
Set selector lever (2) to position “L” = Anti-
clockwise
Switching to drilling/hammer drilling
MPORTANTI
: Only press this switch
whenthemachineisat a standstill,
otherwise the machine may be
damaged.
Forhammerdrillingintiles,cement,or
masonry, put the switch (6) to the position
. Start the machine running in a clockwise
direction at a low speed. Slowly increase the
speedandthepressureonthedrill.
When drilling deeply into cement and rock,
frequently remove the drilling dust by pulling
the bit out of the hole.
8. Service and Maintenance
Beforeperforminganyworkonthe
equipment, pull the power plug.
Useadampclothtocleantheplasticele-
ments. Do not use any cleansers, solvents,
or pointed objects.
Regularly clean any dust that is stuck to the
ventilation openings and moving parts with a
soft brush or a paint brush.
Important.
Storethemachineinsuchawaythat
- it cannot be started by unauthorised persons
and
- nobody can injured themselves on it.
Caution!
Do not leave the machine outdoors or in a
damp environment without protection.
9. Technical Data
B
Rated voltage
230 V~/50 Hz
Keyless drill chuck
Ø 2 – 13 mm
No load speed n
0
0 – 2900 min
-1
Rated power
500 W
Weight
approx. 1,9 kg
Noise pressure level L
pA
93 dB(A)
Noise power level L
WA
104 dB(A)
Uncertainty K
3 dB
Vibration at drilling into metal a
h,D
6,663 m/s²
To Next Page
Loading...