Safety Information
The equipment complies with the safety
regulations required for electrical equip
-
ment.
Read through the instructions for use before starting
up the equipment.
Improper use can lead to personal injury and pro
-
perty damage. Persons, who are not familiar with the
instructions, may not operate the equipment. Keep
the instructions for use in safe custody.
Children and youths are not permitted to operate
the equipment.
Use According to Specifications
The planer is designed for use on wooden materials
such as beams and boards, which must be resting
on a firm surface. It is also suitable for mitring edges
and for rebating.
The manufacture assumes no liability whatsoever for
improper use or if the machine has been tampered
with.
Give equal attention to the safety instructions,
assembly and operating instructions as well as pre
-
vailing accident preventions regulations.
Safety Information
Keep your work area clean and well lit to prevent
accidents.
Don’t use electric devices close to flammable liquids
or gasses or in wet or damp environments. If you fail
to observe this, there is a danger of fire or explosion.
Never leave the device running unattended.
Never use the device when you are tired or lack con
-
centration or if your reactions are impaired due to
consumption of alcohol or medication.
Lack of attention can lead to serious injury.
Keep the tools clean and in good working order in
order to be able to work better and safer.
Don’t wear bulky clothing or jewellery.
Make sure you can stand stably and have shoes that
won’t slip.
Use a head cover if you have long hair.
Loose clothing, jewellery, and long hair can become
entangled in moving parts.
Always wear safety goggles.
Wear a dust mask when working with materials that
produce dust.
Wear ear protection if a lot of noise is produced.
Persons using the machines must not be distracted.
This could cause one to lose control over the tool.
Don’t use any device that has a faulty on/off switch.
An electric tool that can no longer be switched on or
off is dangerous and must be repaired.
Always switch the device on before coming into con
-
tact with the material.
Remove keys and adjusting tools before switching
on the device.
Never overload the machine. If the speed drops,
unload the machine or switch it off. You will work
safer and better with the appropriate electric tool in
a specific area of application.
Stop the workpiece from turning, for example with a
clamping device or a vice. Don’t work on any workpi
-
ece that is too small to clamp in place. If you hold the
workpiece with your hand, then you can’t operate
the tool safely.
Keep electric tools out of the reach of children.
Only use accessories recommended by the manuf
-
acturer.
The mains voltage must correspond to the informati
-
on on the machine’s type plate.
Avoid body contact to grounded elements, e.g.
pipes, radiators, stoves, and refrigerators, to prevent
an electric shock.
Never carry the device by the cable. Only pull the
cable from the receptacle with the plug. Protect
the cable from oil, heat, and sharp edges. Damaged
cables can cause an electric shock.
Check the device and power cable for damage
before starting work.
When plugging in the power plug, make sure that
the operating switch is not located in position.
Only use approved extension cables when using the
device outside.
When using a cable drum, unwind it entirely in order
to prevent the cable from heating up. The minimum
To Next Page
Loading...
Need help?
General
