Rev 1.0For more information about Matrix Fitness: matrixfitness.com | Toll-Free 866.693.4863
Post-installation console setup
Upon completing the install of the Matrix Fitness 7xi cardio equipment, it will be necessary to connect the consoles to the media
gateway that is included with the 7xi equipment.
For Wired Solutions, once the Ethernet cabling that has been installed in the facility, the console should automatically recognize
and connect to the network via the Ethernet Cable.
For Wireless Solutions, the console must be connected to the network via the wireless module built into the console.
From the main screen on the console, Press ENTER,2001,ENTER to obtain a list of the available networks for the 7xi console.
Select ‘Network’ from the left side panel on the screen.
Select ‘Site Survey” to see all available networks.
Select the SSID ‘npwireless’ from the list.
If the facility is using a different SSID, select the correct SSID.
Touch the window provided for entering the pass phrase. A keyboard will pop up.
Enter the password provided by Matrix Fitness for the npwireless SSID.
Press Connect.
Once the Unit is connected to the network, configure the console information in the Service Mode
Press ENTER,3,0,0,1, ENTER on the keypad to Access the Service Mode.
In the GENERAL Tab:
Enter the Console and Frame Serial numbers by pressing ‘EDIT’ by each option and input the correct serial numbers
from the machines.
Press the → button in the bottom right to access the Date and Time menus. Set the date and time accordingly on the unit.
Enter the Facility ID under the Asset Management Menu on the left hand panel.
Select the Weather option on the left side column. Set the default city for the Weather Application. This will confirm that
the console is online and complete the console set up.
To Next Page
Loading...
