Rev 1.0For more information about Matrix Fitness: matrixfitness.com | Toll-Free 866.693.4863
7xi Product Workflow
Here is a list of steps that must be completed for all Matrix Fitness / Johnson Fitness 7xi Cardio Installation.
1. Sales order is placed for 7xi product.
2. Johnson Fitness Creates an Asset Management Facility ID for the customer.
3. If Necessary, Johnson Fitness creates a user ID for the customer to access the Asset Management site.
4. An order is placed with Accucode for all necessary components.
a. All 7xi installations require a media Gateway. Depending on Wired v Wireless, the remaining components will vary.
5. A site survey is performed to determine how many Access Points are required to provide adequate wireless coverage
in the facility. Access points are ordered based on the result of this survey.
a. For Wireless setups only.
6. Network access components are installed in the facility and connected to the facility’s internet line.
a. NOTE – It is highly recommended that the customer install a dedicated internet line for 7xi product to allow
for necessary bandwidth.
7. New equipment is installed.
8. Consoles are set up to connect to the Access Point.
9. Customer can now view equipment online in the Asset Management website.
a. Note – A workout must be completed before the Equipment will report data to the website. It is recommended
that a brief workout is performed directly after turning on Asset Management.
NOTE: Steps 6-8 can be performed in any order. The order provided is the most streamlined process.
All 3 of these steps can be performed at the time of install.
To Next Page
Loading...
