HOW TO OPERATE THE Matrix E-Series
!
!
Red Resistance knob (turn)
Emergency brake (push)
levelling feet
Version 1.0 2013 IC-MXEB-01 Copyright by Indoorcycling Group GmbH 2013 | www.indoorcycling.com ENG 12
Resistance adjustment:
The preferred level of difculty in pedalling (resistance) can be regulated in ne increments
by use of the resistance knob. To increase the resistance, turn the resistance knob
clockwise. To decrease the resistance, turn the knob counter clockwise.
IMPORTANT: To stop the ywheel (wheel) while pedalling, push down on the red brake
knob. The ywheel should quickly come to a complete stop. Please make sure your shoes
are xed into the toe clip or in case cycling shoes are used your shoe cleat is connected
to the pedal binding while riding.
The Matrix E-Series does not have a free moving ywheel (wheel); the pedals
will continue to move together with the ywheel until the ywheel stops. Re-
ducing speed in a controlled manner is required. To stop the ywheel imme-
diately, push down the red break knob. Always pedal in a controlled manner
and adjust your desired cadence according to your own abilities. Push the
red knob down = emergency Stop
If the Matrix E-Series rocks on the oor after
being set down, turn the levelling feet (see
diagram) underneath the front or rear stabi-
lizer until the rocking motion is eliminated.
Important: Please do not unscrew the le-
velling feet more then ½ inch!
How to move the Matrix E-Series:
Due to the weight of the Matrix E-Series, it is recommended that two persons move it. While
one person lifts the back of the Matrix E-Series, the second person rmly holds the hand-
lebarand tips the Matrix E-Series forward until it rolls on the wheels. Carefully move the
indoor studio cycle to the desired location and then lower it. CAUTION: To reduce the risk
of injury, use extreme caution while moving the indoor studio cycle. Do not attempt
to move it over uneven surfaces and make sure a safety space of min 20 inch to the
nearest equipment is redeemed.