Matrix R1x - Managers Custom Mode; List of Managers Custom Modes

27
CHAPTER 6: ManaGer’s Custom Mode
6.1 LIST OF MANAGER’S CUSTOM MODE
The Manager’s Custom Mode allow the club owner to customize the bike for the club.
To enter the Manager’s Custom Mode, press and hold down the “LEVEL ARROW keys“ . Continue to hold down these two keys until the INSTRUCTION
CENTER displays “MANAGER MENU”.
1. To scroll through the list of Manager’s Custom Mode, use the “LEFT / RIGHT ARROW keys”, or “LEVEL ARROW keys”. The INSTRUCTION CENTER will display, in
turn, each of custom settings.
2. To select a custom mode, press the SELECT key to enter.
3. To change the value of the setting, use the “LEFT / RIGHT ARROW keys”, or “LEVEL ARROW keys”.z
4. To confirm and save the value of the setting, press the QUICK START key. “SETTING SAVED” will appear in the INSTRUCTION CENTER. To exit the setting
without saving, press the RESET key within 5 seconds, or if there is no key pressed, the system will resume automatically.
LIST OF MANAGER’S CUSTOM MODES:
P0
P1
P2
P3
P4
P5
P6
99 min
20 min
1
68kg /
150lbs
N/A
20 min
5 min
1
34kg /
75lbs
0
99 min minute
max.
time
10
182kg /
400lbs
104,000
km /
65,000
mile
MAXIMUM
TIME
DEFAULT
TIME
DEFAULT
LEVEL
MAXIMUM
LEVEL
DEFAULT
WEIGHT
DEFAULT
AGE
ACCUMU-
LATED
DISTANCE
CUSTOM
SETTING
DEFAULT MINIMUM MAXIMUM UNIT STEP DESCRIPTION
Control the default program time.
Control the starting resistance level for
all programs.
Control the default weight used in calorie
calculations. Set to default unit change
(kilograms or pounds). Displayed in
native units.
Enable fitness club managers to set the
program maximum workout duration limits
during peak and non-peak hours of club
traffic. Active variable displayed in the TIME
display after change.
Enable to set maximum resistance level for all
programs.
Control the default users age used in target
heart rate calculations.
1
minute 1
1
1
n/a
20 1 20
n/a
30 10 99
age
kg/lbs
1
1
N/A
km /
mile
Accumulated distance is not editable, but only
for display. Displayed in native units (miles or
kilometers). After the equipment reaches the
maximum distance, it will reset to "0"
automatically.